Trouble with 12V Relay attached to Pump - Arduino MEGA2560

I have attached to my Arduino a 2 Channel 12V Relay. Currently the red light on the Relay is working as my program switches LOW and HIGH every 5 seconds, so I know it's communicating. My 12VDC/AC power supply is plugged in the + is spliced in through the orange wire connected to the COM2. On the NO2 I have the +(pos) going to the pump. The -(neg) of the pump is connected to the power supplies -(neg). For some reason I get no response from the NO2 switching on or off. When the red light on the

5-12V DC pump doesn't start through relay - Project Guidance - Arduino Forum

Is there any way I can connect a USB cabled water pump to Arduino Mega 2560? : r/arduino

Can an Arduino use a 12 V relay? - Electrical Engineering Stack Exchange

Guide for Relay Module with Arduino

12V Water Pump Controlled by Arduino and Relay Won't Work - #28 by system - Motors, Mechanics, Power and CNC - Arduino Forum

Arduino And Relay, some help for this little 12v project - Motors, Mechanics, Power and CNC - Arduino Forum

Make Multi-house Water Pump Control System using Arduino

Can't turn on 12v relay with output pins - General Electronics - Arduino Forum

Led Matrix and Water pump with Relay problem - LEDs and Multiplexing - Arduino Forum

Issues with 12v and 12v relay to power a pump - Motors, Mechanics, Power and CNC - Arduino Forum

How to Set Up a 5V Relay on the Arduino - Circuit Basics