Free STL file Shelly H&T Case (external Power Supply) 🔧・3D printable model to download・Cults

This is a simple case for the Shelly H&T sensor. One Base is with mounting points for a step down module one is without them. Both come with a 4mm hole for a USB Cable. The Shelly H&T twists into the lid like in the original case As the Shelly H&T only is rated for 3V you should use some type of voltage regulator! additionaly needed:

• 4 2.9mm x 9mm screws for the lid
• 2 2.9mm x 6mm screws for the step down module if used
• USB Cable
• Voltage regulator / Step down Module

shelly case 3D Models to Print - yeggi

Shelly Case v2 + AddOn by wolf3D

Free STL file Shelly Flood wall holder 🏠・3D printer model to

Shelly Plus 1 DIN rail mount by gregster

Free STL file SHELLY 2.5 MOUNTING CASE 👽・3D printable design to

Shelly H&T Case (external Power Supply) by DirAgAlok

9mm reloding try 3D Models to Print - yeggi - page 12

shelly em din rail wago 3D Models to Print - yeggi - page 13

shelly case 3D Models to Print - yeggi