No 5V+ from Arduino Uno R3 - Motors, Mechanics, Power and CNC - Arduino Forum

My son was using his Elegoo kit I got him. He had done lesson 3 (hardwire an LED), and was doing lesson 4 and could not get it to work. I then plugged in my Arduino Uno R3 to see if it was the Arduino. Same result. So I got out my volt meter, and I'm only getting a few millivolts between the V5 pin and GND. It's possible something was wrong with his circuit that fried the regulator on his board, and then when I plugged mine it it fried mine also? Anyway, I should always get +5 out of the

Arduino Uno Breadboard Tray By Sdhuk Download Free STL, 47% OFF

Arduino Uno Breadboard Tray By Sdhuk Download Free STL, 47% OFF

Arduino Uno Breadboard Tray By Sdhuk Download Free STL, 47% OFF

Arduino Uno Breadboard Tray By Sdhuk Download Free STL, 47% OFF

NEMA 34 stepper with DQ860MA driver - #21 by PlaneCrazy - Motors, Mechanics, Power and CNC - Arduino Forum

CNC Shield with O/A speed control potentiometer? - Motors, Mechanics, Power and CNC - Arduino Forum

Arduino Uno 5 axis wiring - Hardware - Arduino Forum

Arduino Uno Breadboard Tray By Sdhuk Download Free STL, 47% OFF

SOLVED] Bi-directional motor control with two mosfets? - General Electronics - Arduino Forum

Stepper Motor Setup Trouble Shooting CNC Shield V3.0 - AccelStepper.h - Motors, Mechanics, Power and CNC - Arduino Forum

How to power Motor and Arduino with single power source - Motors, Mechanics, Power and CNC - Arduino Forum

main@

I cant drive my dc motor with arduino and L293D IC - Motors, Mechanics, Power and CNC - Arduino Forum

Need Help In Arduino Uno, L298N and Dc Motor - #13 - Motors, Mechanics, Power and CNC - Arduino Forum