Arduino AutoShutdown Using 5V DC Relay or MOSFET - Project

I'm learning how to use relays. I understand their basic function and have managed to build a few projects. But I came across an example that uses a relay or MOSFET to Auto Shutdown Arduino and I'm not sure if I've understood the circuit correctly. When I built this project, the Arduino powers off as soon as I release the button! THIS IS HOW I SEE IT: The relay (which is using NO) is initially LOW, meaning COM and NO are not connected and therefore the Vcc into Arduino's 5V pin is not going to

High Power Motor On/Off with arduino - Interfacing - Arduino Forum

MOSFET IRLZ44N to drive a industrial relay - General Electronics - Arduino Forum

Arduino Microcontroller Self Power Off (with Pictures) - Instructables

The Distributor

Driving a 5v relay with a Nano - LEDs switching but relay itself doesnt - General Electronics - Arduino Forum

Controlling a DC motor with Arduino

5V 2-Channel Relay interface board, and each one needs 15-20mA Driver Current Equiped with high-current relay, AC250V 10A ; DC30V 10A Standard

SunFounder 2 Channel DC 5V Relay Module with Optocoupler Low Level Trigger Expansion Board Compatible with Arduino R3 MEGA 2560 1280 DSP ARM PIC AVR

Over Current Cut-off Power Supply Using Arduino - Homemade Circuit Projects

Raspberry Pi Emergency Power Supply & XY

Arduino DC Motor Speed and Direction Control using Relays and MOSFET