ASA Filament, 3D4Makers

€ 8.99 · 4.6 (189) · In Magazzino

ASA (Acrylonitrile-Styrene-Acrylate) Filament The 3D4MAKERS ASA Filament will be delivered in a vacuum packaging in our recyclable box. Technical information: Acrylonitrile-Styrene-Acrylate (ASA) polymers are amorphous and have mechanical properties similar to those of ABS plastics. However, the ASA properties are far less affected by outdoor weathering. The outstanding weather resistance abilities of ASA is due to the acrylic ester elastomer. ASA parts have good chemical and heat resistance, and high impact strength, even at low temperatures. Typical ASA applications are buiding/construction, automotive and recreation parts. Measurements & Tolerance Size Diameter tolerance roundness 1,75 mm Filament +/- 0,05mm 95% 2,85 mm Filament +/- 0,10mm 95% Physical properties Description Value Test method Density 1,07 g/cm3 ASTM D792 Melt Mass-Flow Rate (MFR) (220ᵒC/10KG) 12 g/10 min ASTM D1238 Mechanical properties Description Value Test method Tensile Stress 47 Mpa ASTM D638 Flexural Modulus 2210 Mpa ASTM
ASA (Acrylonitrile-Styrene-Acrylate) Filament The 3D4MAKERS ASA Filament will be delivered in a vacuum packaging in our recyclable box. Technical information: Acrylonitrile-Styrene-Acrylate (ASA) polymers are amorphous and have mechanical properties similar to those of ABS plastics. However, the ASA properties are far less affected by outdoor weathering. The outstanding weather resistance abilities of ASA is due to the acrylic ester elastomer. ASA parts have good chemical and heat resistance, and high impact strength, even at low temperatures. Typical ASA applications are buiding/construction, automotive and recreation parts. Measurements & Tolerance Size Diameter tolerance roundness 1,75 mm Filament +/- 0,05mm 95% 2,85 mm Filament +/- 0,10mm 95% Physical properties Description Value Test method Density 1,07 g/cm3 ASTM D792 Melt Mass-Flow Rate (MFR) (220ᵒC/10KG) 12 g/10 min ASTM D1238 Mechanical properties Description Value Test method Tensile Stress 47 Mpa ASTM D638 Flexural Modulus 2210 Mpa ASTM D790 Impact strength Notched Izod 180 j/m ASTM D256 Rockwell Hardness (R-Scale) 103 ASTM D785 Printer settings Description Value Printer nozzle temperature 240 - 280°C Heated bed temperature 90 - 110°C Bed Adhesion Magigoo Original on glass or a PEI Sheet To get the best results while printing we advise you to keep the 3D printer in a room where there is hardly any draft and/or temperature fluctuations. Keep the 3D printer out of the sun. This cannot be a room where people sleep. When the 3D printer is not being used it is important to keep the 3D4MAKERS ASA Filament in a bag and stored in a cool, dry and dark place until it is used again.