220V safety control using relay module - General Electronics

Hello. The relay module controls the 220V fluorescent lamp in Arduino. It has been confirmed that the lamp also operates whenever the relay module is switched on and off. But I want to put in a fuse holder because I want to control it while preventing overcurrent more safely, Is it okay to connect the circuit like this?? I'm currently using an Arduino unit3 compatible board. Below is the code used. void setup() { // put your setup code here, to run once: pinMode(9, OUTPUT); } void

25A Solid State Relay SSR DC-DC Input 3-32V DC Load 5-220V ​DC DD220D25

NOYITO 1-Channel Self-Locking Relay Module One Button Start-Stop Bistable 10A Load for SCM Control, Household Appliances Control, Industrial Equipment Control (12V): : Industrial & Scientific

220V safety control using relay module - General Electronics - Arduino Forum

12 Volt DC Solid State Relay using BUZ71A

How to use relay with Arduino to control AC or DC load with bare relay

Voltage Monitoring Relays - Littelfuse

What relay can be used to run a 220V current with an Arduino without using any transistors? - Quora

Controlling 220v using Arduino relay board

Guide for Relay Module with Arduino

Info Byte: The Mystery of Ice Cube Relays–Coil Polarity - Technical Articles